Table of Contents
Advertisement
Visit Radioddity.com For Downloads And Help
a. To confirm your selection, press
MENU
the main menu.
b. To cancel your changes, press
and it will reset that menu item and bring you out of
EXIT
the menu entirely.
6. To exit out of the menu at any time, press the
7. All further examples and procedures in this manual will use the numerical menu
shortcuts.
Chapter 5. - Scanning
The Radioddity GA-5S features a built in scanner for the VHF, 220MHz and UHF bands.
When in Frequency (VFO) mode it will scan in steps according to your set frequency step.
In Channel (MR) mode it will scan your channels.
Dual Watch is inhibited while scanning
To enable the scanner, press and hold the
to exit scanning mode.
Scanning modes
The scanner is configurable to one of three ways of operation: Time, carrier or search,
each of which is explained in further details in their respective section below.
and it will save your setting and bring you back to
key.
EXIT
key for about two seconds. Press any key
Visit Radioddity.com For Downloads And Help
27
1. Press the
key to enter the menu.
MENU
2. Enter
on your numeric keypad to turn to scanner mode.
3. Press the
key to select.
MENU
4. Use the
and
5. Press the
key to confirm and save.
MENU
6. Press the
key to exit the menu.
EXIT
Time operation
In Time Operation (TO) mode, the scanner stops when it detects a signal, and after a
factory pre- set time out, it resumes scanning.
Carrier operation
In Carrier Operation (CO) mode, the scanner stops when it detects a signal, and after a
factory preset time with no signal it resumes scanning.
Search operation
In Search Operation (SE) mode, the scanner stops when it detects a signal.
To resume scanning you must press and hold the
Procedure 5.1. Setting scanner mode
keys to select scanning mode.
key again.
28
Advertisement
Table of Contents
