Table of Contents
Advertisement
Visit Radioddity.com For Downloads And Help
Battery Level Indicator
When the battery level indicator reads
will start beeping periodically as well as flashing the backlight of the display and when
voice prompts are enabled, a "Low Voltage" announcement will be heard, indicating that
you need to change your battery or put your radio in the charger.
Status LED
The status LED has a very simple and traditional design. When you receive a signal it
shows green, when you transmit it shows red, and it's off in standby.
Side key 1 - CALL (Broadcast FM and Alarm)
Press
momentarily to start the broadcast FM receiver. Another momentary press turns
the broadcast FM receiver off. If a signal is received on the active frequency or channel
while you are listening to the broadcast FM, the squelch will be activated to that frequency
(as if scanning) and remain there until the signal goes away; it will then switch back to
broadcast FM.
Press and hold
to activate the alarm function. Press
off.
the battery is depleted. At this point the radio
(a short press) again to turn it
Visit Radioddity.com For Downloads And Help
14
Side key 2 - MONI (Monitor and Flashlight)
Press
momentarily to turn on the LED flashlight. Another momentary press will flash
the LED. Another momentary press turns the flashlight off.
Press and hold
to the unfiltered signal.
Pressing
switches between Frequency (VFO) Mode and Memory (MR) mode.
VFO/MR
Memory mode is sometimes also referred to as Channel mode.
To save frequencies to channel memory you must be in Frequency (VFO) mode.
The
key switches between A (upper) and B (lower) displays. The frequency or
A/B
channel on the selected display becomes the active listening and transmit frequency
or channel.
to monitor the signal. This will open up the squelch so you can listen
VFO / MR - mode key
A / B select key
15
Advertisement
Table of Contents
