Radioddity GA-5S User Manual page 36

Visit Radioddity.com For Downloads And Help
SITE [0]: Sounds alarm through
your radio speaker only
TONE [1]： Transmits a cycling
tone over-the-air
AL-MOD – Alarm
Mode CODE [2]： Transmits
'119'(911 in
reverse?) followed by the ANI
code over-the-air
VHF(0) UHF(1)
Band
TDR-AB–Transmit
selection while
OFF[0] | A[1] | B[2]
in Dual Watch
mode
STE - Squelch Tail
OFF[0] | ON [1]
Elimination
RP-STE - Squelch
OFF [0] | 1 - 10
Tail Elimination
60
SITE: Sounds alarm through your radio
speaker only
TONE: Transmits a cycling tone over-the-air
CODE: Transmits '119'（911 in reverse?)
followed by the ANI code over-the-air
Bandsetting
When enabled, priority is returned to
selected display once the signal in the
other display disappears.
This function is used eliminate squelch
tail noise between Radioddity
handhelds that are communicating
directly (no repeater).Reception of a 55
Hz or 134.4 Hz tone burst mutes the
audio long enough to prevent hearing
any squelch tail noise.
This function is used eliminate squelch
tail noise when communicating through
a repeater
Visit Radioddity.com For Downloads And Help
RPT-RL - Delay
OFF [0] | 1 - 10
the squelch tail of
repeater
FULL [0]: Performs an LCD
PONMSG - Power
screen test at power-on
On Message MSG [1]: Displays a 2-line
power-on message
ROGER- Roger
OFF [0] | ON [1]
Beep
RESET - Restore
VFO [0] | ALL[1]
defaults
61
Delay the Tail Tone of Repeater(X100
milliseconds)
Controls the behavior of the display when
the transceiver is turned on.
Sends an end-of-transmission tone to
indicate to other stations that the
transmission has ended.
Resets the radio to factory defaults,
with some exceptions.