Monitor Mode Feature; Channel Scanning; Using The Flashlight - Radioddity FS-T7 FRS US User Manual

transmission, pause slightly after pressing the [PTT] button before you start talking.
2) When you have finished speaking, release the [PTT] button. You can now receive incoming calls. While receiving,
RX displays.

Monitor Mode Feature

Your radio allows you to listen for weak signals on the current channel at the press of a key. To turn ON Monitor
mode: Press and hold [
noise and weak signals can be heard. The RXicon blinks. To turn OFF Monitor mode: Press and hold [
for 2 seconds to return to "Normal" mode; two beeps sound and the RX icon stops blinking and disappears.

Channel Scanning

FS-T7 can automatically search for signals throughout the FRS bands by scanning, i.e. selecting the channels in rapid
sequence. When a signal is detected, the scanning pauses on that channel and you can transmit by pushing [PTT]. If
you press [PTT] during scanning you can transmit on the channel from which the scanning started. The scroll
buttons [ ] or [ ] allow you to change the direction of scanning (from lower channels to higher ones or vice
versa) and therefore to skip communications which are of no interest.
Press briefly the button [ /SCAN] to start scanning.
If you want to stop it, press again [ /SCAN]. Your transceiver will go back to the channel from which the scanning
originally started.
Scanning Sub-Codes
Press and hold [ /SCAN] button to enter the Sub-Codes scanning.
A flashing "CTC/DCS" will be in the left status display to indicate the radio is in Sub-Codes scanning mode.
In this mode, the lower display will cycle through the Sub-Codes as they are being tested. Once the bits of the
received Privacy code are determined, the "CTC/DCS" indicator will stop flashing.
Press the [PTT] button to save the scanned tone into memory.
During scanning, press and hold [ /SCAN] button to exit Sub-Code scanning.

Using the Flashlight

You can use this radio in an emergency. If you press [ ] button, the radio turns on the high-intensity LED flashlight
on your radio.
• Your radio operates normally when the emergency strobe is activated.
/MONI] for 2 seconds until two beeps sound. The receiver circuit stays open, and both
7
/MONI]