Table of Contents
Advertisement
Visit Radioddity.com For Downloads And Help
Procedure 8. 2. DCS setup how-to
1. Press the
key to enter the menu.
MENU
2. Enter
on the numeric keypad to get to receiver DCS.
3. Press
to select.
MENU
4. Enter desired DCS code on the numeric keypad.
5. Press
to confirm and save.
MENU
6. Enter
on the numeric keypad to go to transmitter DCS.
7. Press
to select.
MENU
8. Enter desired DCS code on the numeric keypad. Make sure it's the same code as that
you entered for receiver DCS.
9. Press
to confirm and save.
MENU
1000Hz, 1450HZ, 1750HZ Tone-burst
To send out a tone-burst; you simultaneously will press a key while holding down the PTT.
No further configuration required using this feature.
The following configurations will transmit accordingly:
PTT +
= Transmits 1000Hz Tone Burst
PTT +
= Transmits 1450Hz Tone Burst
VFO/MR
PTT +
= Transmits 1750Hz Tone Burst
A/B
39
Visit Radioddity.com For Downloads And Help
If you have the keypad lock enabled on your radio, you can still send a 1750H/z
tone the regular way without having to unlock your radio.
The Radioddity GA-5S allows for customization of both the power-on message (via
computer link only), and the backlight color during the three states of the transceiver
(Transmit, Receive and Standby).
The LCD on the Radioddity GA-5S is backlit by multi-color LEDs, the color of which can be
pre-set from the menu system into a variety of colors.
To change the colors, follow these steps:
1. Press the
MENU
2. Enter one of the following on your numeric keypad
a.
to change the standby color
b.
to change the receive color.
c.
to change the transmit color
3. Press
key to select
MENU
Chapter 9. - Customization
Display
Procedure 9. 1. Changing backlight color
key to enter the menu.
40
Advertisement
Table of Contents
