Boost Pressure Sender Assembly - BD X-MONITOR Installation Manual

6 November 2006

Boost Pressure Sender Assembly

Push this end into the supplied fitting (see diagram below) and connect the rubber
hose to the pressure sensor on the back of control box. MAKE SURE TO USE THE
RUBBER HOSE AND NOT THE PLASTIC TUBING WHEN MAKING THIS
CONNECTION.
NOTE: The module should be mounted with the boost fitting pointed down.
Ship: 88 – 446 Harrison St, Sumas, WA 98295
1085200/5210/5220 Dodge X-Monitor
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
Locate and remove one of the intake
plenum-to-manifold bolts and install
the drilled bolt provided with this kit
and tighten
specifications. (These bolt holes all
open into the intake manifold)
Attach one end of the supplied 6'
piece of 1/8" plastic air hose onto the
open fitting and route it through the
firewall by piercing a large rubber
grommet beside the brake booster
canister.
Route the hose into the cab under
the dash taking care not to kink the
tubing and to keep it away from hot
and moving parts.
Mail: PO Box 231, Sumas, WA 98295
to the proper
7