Fuel Pressure Sensor Power And Ground; X-Monitor Power And Ground - BD X-MONITOR Installation Manual

6 November 2006

Fuel Pressure Sensor Power and Ground

A 5V source is needed to power the auxiliary fuel pressure sensor. A recommended
location to tap onto is the MAP (Manifold Absolute Pressure) sensor located near
the driver's side rear portion of the engine block. On 1998½-2002 model trucks it is
located on the side of engine at the rear; on 2003-2007 model trucks it is located on
the top of the engine, near the rear. Use the supplied Posi-Tap to pierce this wire
and use the red wire to route power to the sensor connector assembly.
The ground connection can be routed back towards and connected to the battery.
5 Volt Supply – Located at the MAP Sensor
Model Year
1998½-2001
2004-2007

X-Monitor Power and Ground

Locate a switched 12-volt power source under the dash and install the Red wire to it.
Install the other end to the Power connector of the control box.
Install the Black ground loop to a good ground and install the other end to the
Ground connector of the control box.
Ship: 88 – 446 Harrison St, Sumas, WA 98295
1085200/5210/5220 Dodge X-Monitor
2002 Violet w/ White tracer
2003 Dark Green w/ Orange tracer
Pink w/ Yellow tracer
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
Wire Color
Orange
Mail: PO Box 231, Sumas, WA 98295
2003-06
MAP
1998½-02
MAP
Pin
A
3
C
C
18