Programming And Set Up - BD X-MONITOR Installation Manual

6 November 2006 1085200/5210/5220 Dodge X-Monitor 20

Programming and Set Up

Press both buttons in on the X-Monitor display
and set your ignition into KOEO mode (Key
On / Engine Off). The X-Monitor screen
should light up and after the boot-up has
completed, the words "SIDE OR TOP BTN?"
should appear and the bottom line should read
"SIDE". Let go of both buttons. Press the
bottom button (if using the A-Pillar mount) to
go to the next screen (if you are installing a universal (top) mount, hit the top button).
You will now get a screen that will read "PART:" on the top line and "1080000" on
the bottom line. Using the programming chart located on the next page, find the
program number that matches the application and measurements you are going to
program the X-Monitor for. Press the top button until the program number appears,
then press the bottom button to activate that program (see diagram below). The
display will now cycle through the normal start-up screens that will appear every
time the truck is started.
A fter the program has been set, the boot-up screen should display the following:
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ship: 88 – 446 Harrison St, Sumas, WA 98295 Mail: PO Box 231, Sumas, WA 98295
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com