Lift Pump Fuel Pressure (1998½-2002) - BD X-MONITOR Installation Manual

6 November 2006
Lift Pump Fuel Pressure (1998½-2002)
Ship: 88 – 446 Harrison St, Sumas, WA 98295
1085200/5210/5220 Dodge X-Monitor
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
Apply some pipe 'dope' or Teflon
tape to the supplied pressure
sender, and then insert and tighten
the sender into the brass banjo bolt
fitting supplied.
Locate the fuel filter on the left
hand side of the engine just in front
of the fuel lift pump.
At the rear of the filter housing is a
fuel inlet line and pressure test
fitting. Remove the test fitting and
then remove the washers.
CAUTION: Fuel will escape from
this line, ensure a small drip pan
or some rags are in place to
prevent excessive
leaking.
Install one of the new washers
(supplied in the kit) onto the
supplied banjo bolt fitting.
Mail: PO Box 231, Sumas, WA 98295
14
fuel from