Table of Contents
Advertisement
6 November 2006
1085200/5210/5220 Dodge X-Monitor
19
Display Assembly Installation
* * * E X T R E M E
C A U T I O N * * *
THE DISPLAY IS VERY FRAGILE AND IS INSTALLED AND TESTED
AT THE MANUFACTURER. IF YOU MUST REMOVE THE DISPLAY IN
ORDER TO PAINT THE PILLAR MOUNT TAKE EXTREME CARE
DURING
RE-INSTALLATION.
DO
NOT
OVER-TIGHTEN
THE
MOUNTING SCREWS OR THE DISPLAY WILL BE DAMAGED AND
YOUR
WARRANTY WILL BE VOIDED.
A-Pillar Mounts
These mounts go over top of your existing OEM A-Pillar. Place the display assembly
onto the A-pillar to determine the best mounting location and mark this location on
the pillar. Remove the A-pillar for ease of installation.
While holding the display assembly on top of your A-Pillar (in the place where you
would like to mount it), drill 3/16" holes into the corners of the display assembly
mount and through the A-pillar.
Drill a hole through the A-pillar, large enough for the display control wiring connector
to pass through (Optional - This hole is NOT required if you decide to run wiring
along the outside of the A-pillar).
Install the telephone type communication cable into the back of the display circuit
board and route the wiring through the drilled hole or along the outside of the pillar
as preferred.
Insert the supplied ratchet fasteners through the drilled holes and into the A-pillar
securing the X-Monitor display assembly to the A-pillar. Install the A-pillar into place
and route the control wiring down to the control box.
Insert the telephone type connector in the socket of the control box. Once all
connections are made, secure the box in place under the dash and away from any
moving parts.
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ship: 88 – 446 Harrison St, Sumas, WA 98295
Mail: PO Box 231, Sumas, WA 98295
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
Advertisement
Table of Contents
