Advertisement
8. Uncheck the Use hardware handshaking checkbox.
9. Select OK to save the settings and return you to the New
Config dialog.
10. Select Euro from the Receiver Type choices in the Receiver
Options section.
11. Select the OK button to close and create the new device
configuration.
12. Select the new configuration from the Available device con-
figs list in the Open dialog box.
13. Select Open to open communications with the EuroPak.
USING GPSOLUTION
GPSolution provides access to key information about your
receiver and its position. The information is displayed in windows
accessed from the View menu. For example, select View | Posi-
tion Window from the menu to display the antenna position. To
show details of the GPS and geostationary (SBAS) satellites
being tracked, select Tracking Status Window from the menu.
1. GEO channels must be assigned manually using the ASSIGN
command. Select an SV channel number to apply the
command to where 0 is the first SV channel and 17 is the last:
0 to 7 for GPS and 8 for GEO (MEDLL models) or,
0 to 13 for GPS and 14 to 17 for GEO (non-MEDLL models)
Examples:
ASSIGN 0 ACTIVE 29 0 2000
ASSIGN 15 120 -250 0
ASSIGN 11 28 -250 0
The first example sets the first SV channel to acquire satellite
PRN 29 in a range from -2000 Hz to +2000 Hz until the satellite
signal has been detected. SV channel 11 is set to acquire
satellite PRN 28 at an offset of -250Hz only in the third
example.
Refer also to the ASSIGN and CHANCONFIG commands in the
EuroPak User Manual for more details.
2. The Channel Tracking Status Window automatically resizes
based on the number of channels tracking.
AVIATION STATUS WINDOWS
Aviation's GPSolution offers three additional status windows for
your receiver: AGC Status, Receiver Status and Receiver
Hardware Status
ENTERING COMMANDS
The EuroPak uses a comprehensive command interface.
Commands can be sent to the receiver using the Console
window in GPSolution, which is opened from the View menu.
Enter commands in the text box at the bottom of the window.
The following information is important when entering commands:
• Commands must be entered in Abbreviated ASCII format.
• Press the Enter key to send the command string to the
receiver.
• The commands are not case sensitive.
Your EuroPak user manual provides all the available commands
and the parameters they use for the Abbreviated ASCII format.
The Console window displays Abbreviated ASCII output. To view
ASCII output you must open the ASCII Messages window.
QUESTIONS OR COMMENTS
If you have any questions or comments regarding your EuroPak,
please contact the NovAtel Aerospace & Defense Group using
any one of the following methods:
Email: support@novatel.ca
Phone: 1-800-NOVATEL (U.S. & Canada)
403-295-4900 (International)
Fax: 403-295-4999
Web: www.novatel.com
© Copyright 2005-2010 NovAtel Inc. All rights reserved.
Printed in Canada on recycled paper. Unpublished rights reserved under inter-
national copyright laws. Recyclable.
GM-14915058
Rev 2
2010/08/30
Advertisement
