DSC LE4000 Installation Manual page 20

LE4000 Installation Manual
Note: The Blue LED is always OFF when the LE4000 is used as the primary communicator.
# of Trouble Type
Flashes
Red Blue
ON ON No Signal Strength
1 OFF Wireless Network Trouble
2 OFF Battery Trouble
3 OFF Input Power Trouble
1 FLASH Insufficient Signal Strength
2 FLASH Not Used
3 FLASH C24 Communications Con-
figurations Trouble
1 ON Radio/SIM Trouble
2 ON Receiver Not Available Trouble
3 ON Supervision Trouble
4 ON Tamper Trouble
The Red light flashes to indicate various trouble conditions outlined previously. If multiple trouble conditions are present, the red LED
flashes according to the highest priority trouble. For example, if both a LE4000 wireless network trouble (one flash) and a low battery
trouble (two flashes) are present; the red LED flashes one time. Once the LE4000 wireless network trouble condition is corrected, the
red LED begins flashing two times to indicate the low battery trouble.
Trouble Notes
Verify SIM card is activated.
l
Ensure the antenna cable is plugged securely into the radio connector.
l
If the SIM is active, connect a battery to the unit and test various locations for
l
good/excellent signal strength.
Connect an antenna extension kit (LTE-8ANT, LTE-15ANT, LTE-25ANT,
l
LTE-50ANT).
Ensure the SIM card has been activated.
l
The antenna cable should be plugged securely into the radio connector.
l
Ensure there is good signal strength (at least one green light ON).
l
Verify the installation area is not experiencing a network outage.
l
If a battery is not used in the installation, ensure that the "Internal Battery
l
Connected" is not selected in C24 Communications.
If a battery is used in the installation, verify the battery is connected properly
l
Measure the battery under load and verify it is charged to at least 7.2VDC. If
l
not, wait at least 1 hour for the battery to charge.
Remove the battery and measure the voltage; the voltage should be at least
l
7.2VDC.
Verify the input DC supply is rated at 13.8VDC @ 180mA minimum.
l
Replace battery
l
Ensure the power source connected to the LE4000 is providing 13.8VDC @
l
180mA.
Ensure the antenna cable is plugged securely into the radio connector.
l
If the SIM is active, connect a battery to the unit and test various locations for
l
good/excellent signal strength.
Connect an antenna extension kit (LTE-8ANT, LTE-15ANT, LTE-25ANT,
l
LTE-50ANT)
Ensure the SIM card is activated and correctly initialized through C24
l
Communications.
Ensure the SIM Card is inserted correctly and firmly.
l
Ensure the antenna cable is plugged securely into the radio connector.
l
Contact the monitoring station to verify that the LE4000 programming is
l
correct (port, IP address, DNIS).
Contact your central station to verify they are not experiencing any receiver
l
issues.
Contact your central station to verify they are not experiencing any receiver
l
issues.
Ensure the front cover is secured and the case tamper is closed.
l
20