Helpful Calibration Tips; Second Fill-Up Procedure - Linear Logic ScanGauge II User Manual

Helpful Calibration Tips:

•
When filling the tank on your second fill-up, try to use the same
pump you used for your first fill-up with the vehicle pointed in the
same direction. If you fill up your fuel tank with your vehicle on an
incline, it can have an effect on the amount of fuel the pump can
dispense into your tank.
•
When filling your tank, let the pump shut off automatically.
Do not top off.
•
To maintain accurate "TO EMPTY" information in the
ScanGauge's trip computers, you should always fill your tank to
capacity and follow the FILLUP sequence in Step 2.
•
Once you have completed your second fill-up, subsequent fill-ups may not require adjusting the
gallons/liters before pressing DONE.
Step 2
- Your Second Fill-up and Subsequent Fill-ups
Home Screen
<SCAN
<TRIP
<DISPLAY FILLUP>
<SETUP
< 14.3 GALLONS
0.0%
< $3.00
Fuel Cost
Once you have set the fuel
cost, press SAVE.
GAUGE>
MORE>
1) When the tank is around 1/4 full, fill up your tank
2) Use the FILLUP function to tell ScanGauge you have
MORE>
3) The next screen will show the amount of fuel your
>
DONE>
4) Push the lower right function button to save the value
>
SAVE>
5) Next, the Fuel Cost screen will appear. Enter the cost per
After following the initial
calibration procedure, you
should follow Step 2 for each
subsequent fill-up.
If you miss a fill-up procedure
after filling your tank, start with
Step 1 of the calibration process
on your next fill-up to maintain
accuracy.
again. Be sure to let the pump shut off automatically
filled the tank. From the Home Screen, follow the
sequence shown to the left.
ScanGauge believes was used since the previous fill-up.
Use the upper left and right function buttons (A,C) to
adjust the amount of fuel you actually put in the tank.
and complete the fill-up process.
gallon/liter and press the SAVE button.
Set Up and Callibration
21