Page 1
INSTALLATION INSTRUCTIONS FOR PART 99-8206 APPLICATIONS Toyota 4-Runner 2003-2009 (Excluding Limited) Toyota Highlander 2001-2007 99-8206 KIT FEATURES • DIN head unit provision with pocket • ISO DIN head unit provision with pocket KIT COMPONENTS • A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Highlander Brackets • E) 4-Runner Brackets WIRING &...
Page 2
99-8206 Table of Contents Dash Disassembly – 2003-2009 Toyota 4 Runner (Excluding Limited) – 2001-2007 Toyota Highlander Kit Assembly – Toyota 4-Runner bracket assembly – Toyota Highlander bracket assembly – DIN head unit provision – ISO DIN head unit provision...
Page 3
Dash Disassembly 99-8206 Toyota 4-Runner 2003-2009 (Excluding Limited) 1. Unsnap and remove trim from around shifter. 2. Unsnap and remove trim covers from around center console pocket edge at front and rear of console. 3. Unsnap and remove center console cover.
Page 4
Dash Disassembly 99-8206 Toyota 4-Runner 2003-2009 (Excluding Limited) 7. Remove (1) 10 mm bolt beneath climate control behind pocket door. Unsnap and remove climate control. (Figure C) 8. Remove (2) 10 mm bolts beneath radio behind climate controls. 9. Unsnap and remove entire center panel around radio.
Page 5
Dash Disassembly 99-8206 Toyota Highlander 2001-2007 1. Pull and remove dash panel from radio and climate controls. Tip: There are 8 clips. (Figure A) 2. Remove (6) 10 mm bolts from radio and climate controls assembly. (Figure B) 3. Remove assembly and disconnect the wiring.
99-8206 Kit Preparation 1. Snap the appropriately marked mounting brackets for your application onto the sides of the radio housing. The brackets are marked 4-Runner or Highlander and left or right. (Figure A - 4 RUNNER) (Figure B - HIGHLANDER)
Kit Assembly 99-8206 DIN head unit provision with pocket 1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation.
Page 8
Kit Assembly 99-8206 ISO DIN head unit provision with pocket 1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation.