Advertisement
Quick Links
INSTALLATION INSTRUCTIONS FOR PART 99-8216
Yaris
(Excludes models equipped with power package)
99-8216
KIT FEATURES
• DIN Radio Provision with pocket
• ISO Radio Provision with pocket
KIT COMPONENTS
A) Radio Housing B) Housing Brackets-3 Door C) Housing Brackets-4 Door D) ISO Snap In Brackets
A
Phillips Screwdriver
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
APPLICATIONS
Toyota
2007-2010
B
C
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wire harness:
• 70-1761 Toyota 1987-up
• TYTO-01 Toyota amp interface harness 2003-up
Antenna adapter:
• Not required
TOOLS REQUIRED:
• Socket Wrench •
Small Flat Blade Screwdriver or
www.metraonline.com
D
Panel Removal Tool
E) Trim Plate
E
Advertisement
Related Manuals for Metra Electronics 99-8216
Summary of Contents for Metra Electronics 99-8216
- Page 1 INSTALLATION INSTRUCTIONS FOR PART 99-8216 APPLICATIONS Toyota Yaris 2007-2010 (Excludes models equipped with power package) 99-8216 KIT FEATURES • DIN Radio Provision with pocket • ISO Radio Provision with pocket KIT COMPONENTS A) Radio Housing B) Housing Brackets-3 Door C) Housing Brackets-4 Door D) ISO Snap In Brackets...
- Page 2 99-8216 TABLE OF CONTENTS Dash Disassembly Yaris 2007-2010 ........1 Kit Assembly Din Mount Radio Provision with pocket.
- Page 3 99-8216 DASH DISASSEMBLY YARIS 2007-2010 Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip the bottom trim panel located underneath the A/C Controls. Figure A) Unclip the two side trim panels that surround the A/C Controls and Radio.
-
Page 4: Kit Assembly
99-8216 KIT ASSEMBLY DIN MOUNT RADIO PROVISION NOTE: Refer also to the instructions included with the aftermarket radio. Slide the Mounting Brackets onto the sides of the Radio Housing until the side clips engage. Note: Tabs are marked 8216-3L and R for the 3 door Yaris and 8216-4L and R for the 4 door Yaris. -
Page 5: Iso Mount Radio Provision
99-8216 KIT ASSEMBLY ISO MOUNT RADIO PROVISION NOTE: Refer also to the instructions included with the aftermarket radio. Slide the Mounting Brackets onto the sides of the Radio Housing until the side clips engage. Note: Tabs are marked 8216-3L and R for the 3 door Yaris and 8216-4L and R for the 4 door Yaris. -
Page 6: Final Assembly
Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short circuit. - Page 7 99-8216 NOTES...
- Page 8 99-8216 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV. 04/26/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-8216...