Table of Contents
Advertisement
Preparing and Installing the Hardware
2
Port
Serial Ports
1 through 4
Printer Port
Ethernet Port
SCSI Interface
Port
Interconnection Connector
SCSI
2-14
Cables recommended for use with the connectors are also listed in
the table. Note that not all peripheral cables needed are provided
with the MVME712M; you may need to fabricate or purchase
certain cables.
Table 2-2. Cables and Connectors
MVME712M Front Panel
Connector
J7 through
25-pin female DB-25
J10
connectors that cable to
your serial devices
J5
36-pin female connector
that cables to your printer
J6
15-pin female DB-15
connector that cables to
your Ethernet network
controller, or connects to
an adapter box
J4
50-pin female connector
that cables to your SCSI
devices
MVME712M Board
J3
50-pin male IDC
connector that cables to J3
on the P2 adapter board
and/or to SCSI devices, in
almost all configurations
Description
User-supplied serial EIA-
232-D DTE or DCE cable
User-supplied Centronics-
type parallel printer cable,
male-to-male
User-supplied network
cable or user-supplied
adapter box to convert to
another medium
User-supplied 50-conductor
cable with SCSI
connector(s) as needed
Description
In the external-only SCSI
configuration labeled
"Configuration E" in Table
2-3 and Figure 2-18, use the
17.5-inch 50-conductor flat-
ribbon cable, part number
30-W2960B01A, furnished
with the MVME712M
For other configurations, a
user-supplied 50-conductor
cable with SCSI
connector(s) as needed
Cable
Cable
Advertisement
Table of Contents
