Preparing and Installing the Hardware
2
DTE/DCE Configuration Select Headers
2-2
The factory default configurations are shown in the following
paragraphs with descriptions of each header. The module is
operational with the factory-installed jumpers.
You can change the jumper settings on the following headers to
establish the DTE or DCE configuration and the Serial Port 4 clock
configuration:
These headers ...
J1, J11, J13, J14, J16 - J19
J15
Serial Ports 1 through 4 can be configured as a modem (DCE) for
connection to terminal or configured as a terminal (DTE) for
connection to modem. The MVME712M is shipped with the ports
configured for DTE operation.
Configuration of each port is accomplished by positioning jumpers
on one of two headers for each port:
These headers ...
J1 and J11
J16 and J17
J13 and J14
J18 and J19
Configure the ...
DTE/DCE
Serial Port 4 clock
Configure these
serial ports ...
1
2
3
4