Metro Cell - Indoor Cabling - Alcatel-Lucent 9363 Installation And Commissioning Manual

Metro Cell installation and commissioning
....................................................................................................................................................................................................................................

Metro Cell - Indoor cabling

Purpose
This topic describes the procedures to be followed when connecting the Metro Cell -
Indoor cables.
Power supply options
Power can be supplied to the Metro - Cell using two different methods.
Power over Ethernet (PoE)
Power can be supplied to the Metro Cell - Indoor using 48V PoE+ (Power over Ethernet)
via the Ethernet cable connection. The Ethernet cable has to be connected to a PoE+
capable router.
If no PoE+ capable router is available, a 48V DC Power Injector must be installed
between the router and the Metro Cell - Indoor.
For installation instructions, refer to the user guide located in the Power Injector box,
document number 06-0062-056.
External AC/DC power adaptor
When power is suppled using an external power adaptor, the Power Injector is not used.
If an external AC/DC power adaptor is used the power adaptor cord connects to the power
supply jack on the Metro Cell - Indoor.
Before you begin
Connect the pair of omnidirectional antennas to the antenna connectors on the device.
Important! Alcatel-Lucent recommends that the antenna connection nuts are torqued
to between 0,7 N.m minimum and 1,1 N.m maximum in order to avoid a potential
loose connection.
....................................................................................................................................................................................................................................
3-8 Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
Metro Cell - Indoor cabling
Alcatel-Lucent 9363 MC
401-387-097
Issue 1 May 2011