10. Quit NVMMemoryUtility.
11. Disconnect the connection of each equipment.
12. Replace the SY-378 board (refer to Section 1-5-4) or IC1002 to IC1004.
13. Perform steps 1 to 7 of this section.
14. Click the radio button of "Memory Write".
15. Click the [Open] button, then select the fi le saved in step 9.
[Open] button
[Write] button
Fig. 2-6d
16. Click the [Write] button.
Fig. 2-6e
17. Click the [Yes] button.
The writing starts.
18. After the writing is completed, click the [Close] button.
19. Disconnect the connection of each equipment.
2-8 (E)
SRX-R320