ICP DAS USA I-7521 User Manual page 48

Type 8
Press ENTER to confirm
Step 9: Set the Stop bit of the 7188xw to 1.
Press ALT + C. Type 1
Press ENTER to confirm
Step 10: Change the 7188xw to Command Line Mode.
Press ALT+ L
The following screen will be shown:
............................
Current work directory="D:\vic\7188\DEMO_v2.9\BC\DEMO32"
original baudrate = 115200!
now baudrate = 115200!
7188xwCmd:B9600original baudrate = 115200!
now baudrate = 9600!
Current baud rate is 9600
7188xwCmd:n
Change data format to N,8,1
7188xwCmd:8
Change data format to N,8,1
7188xwCmd:1
Change data format to N,8,1
{change to Line Mode}
Step 11: Switch on the power to the I-752N module (disconnect the INIT* and
GND pins) and check that the display on the 5-digit, 7-seg LED is as
below: (For firmware version 3.02 and above, see Note*)
I-7521/I-7522/I-7522A/I-7523/I-7524/I-7527 User's Manual,Ver2.5 Aug.2015
48