ICP DAS USA I-7521 User Manual page 47

3
When this dialog appears,
just click "OK"
Step 5: Select the active COM port for the Host PC.
If the I-752N is connected to COM1 on the PC, then press ALT + 1
If the I-752N is connected to COM2 on the PC, then press ALT + 2
The following screen will be shown:
See note
** below
**: Illustrates a real time configuration for the 7188xw. If the configuration is not
9600, N, 8, 1, refer to Steps 6 to 9 below to make the correct settings.
Otherwise, go directly to Step 10.
Step 6: Set the Baud Rate of the 7188xw to 9600.
Press ALT + C
Type b9600
Press ENTER to confirm
Step 7: Set the Parity bit of the 7188xw to N.
Press ALT + C
Type n
Press ENTER to confirm
Step 8: Set the Data bit of the 7188xw to 8.
Press ALT + C
I-7521/I-7522/I-7522A/I-7523/I-7524/I-7527 User's Manual,Ver2.5 Aug.2015
47