Connection To A Receiver; Configuration Of The Ar5000 Receiver; Configuration Of The Companion Receivers - AOR SDU5600 Instruction Manual

Professional spectrum display unit for use with a companion receiver

Hide thumbs Also See for SDU5600:

Table of Contents

4. DC 12 V

Connect the supplied AC adapter to this connector. If you wish to operate with 12 V

external regulated power supply, it should have a minimum continuous capacity of 1 A

or higher, ideally a 2 A (or higher) supply should be used.

The connector complies with EIAJ RC-5320A and is wired center positive (+), outer

negative (-).

3 Connection to a receiver

Before connecting the SDU5600 to a receiver, the power switch of the SDU5600 and the

receiver must be turned off.

In order to control the AR5000 receiver, the following setting is required to the AR5000

receiver.

Connect an AC adapter to the SDU5600.

Connect the DB-9 interface cable between the RX CTR connector on the rear panel of

the SDU5600 and the REMOTE connector on the rear panel of the AR5000 receiver.

Connect the included BNC cable between the RF IN connector of the rear panel of the

SDU5600 and the IF OUT connector on the rear panel of the AR5000 receiver.

Your SDU5600 may be used with the following companion receivers.

Baud rate: 9600 bps

External IF output: EXT – IF1

(Note: See details on page 29 of the AR5000 instruction manual.)

(Note: Some receivers require modifications.)

Table of Contents