SHENZHEN GETECH TECHNOLOGY CO,.LTD
For detailed method, please refer to:
http://www.geeetech.com/forum/viewtopic.php?f=13&t=17037
7.3 Motors can't work
When your are testing the motors, if the motor of an axis has no response or can not work normally (the
extruder can work when it is above 170℃), you need check whether the motor, motor driven board or
voltage of this axis can work normally or not. Meanwhile you need make sure whether the bearing is
damaged or not, whether the smooth rod/screw rod is bent or not, whether the tension of belt is normal or
not, whether each axis is installed correctly or not. For detailed solutions, please refer to:
http://www.geeetech.com/forum/viewtopic.php?f=17&t=17038
7.4 Extruder can't work/ extrusion not fluent
When you are testing the extruder, make sure the temperature is over 170℃. If you find that the extruder
29