Xerox Phaser 6510 User Manual page 141

Symptom
Only one color is faded.
Color around the edge of printing
is incorrect.
Stray black dots or white areas
(dropouts).
Probable Causes
The settings in the application or
print driver are incorrect.
The paper is damp.
The high-voltage supply is
defective.
Toner cartridge is empty or
damaged.
The color registration is incorrect.
The paper is outside the
recommended specification range.
There is debris on the rollers.
The toner cartridges are not
Xerox ® toner cartridges.
Troubleshooting
Solutions
driver match the paper loaded in
the tray.
Print the Demo Page. For details,
refer to Printing Reports. If the
Demo Page looks correct, the
printer is printing properly. Verify
that the application and the print
driver selections are correct for
your print job.
Replace the paper.
For assistance, go to the Xerox
Support website at www.xerox.
com/office/6510support.
Check the condition of the toner
cartridge and replace it if
necessary.
Adjust the color registration. For
details, refer to Color Registration.
Replace the paper with a
recommended size and type, and
confirm that your control panel
and print driver settings are
correct. For details, refer to
Supported Paper.
Wipe the feed rollers with a clean
damp cloth to remove debris from
the rollers.
Do not touch the transfer roller or
the exposed end of the transfer
belt. Fingerprints can cause print-
quality issues.
Ensure that the toner cartridges
meet specifications and replace
Xerox ® Phaser ® 6510 Printer
User Guide
®
141