Steering Wheel Installation - Recharge Mower G2 Safety & Operating Instructions Manual

Before you open the carton of your New Recharge Mower®, please review the following:
WE RECOMMEND YOU HAVE A SECOND PERSON ASSISTING BEFORE YOU BEGIN.
 Remove the over shipper carton by lifting it straight up and over the enclosed metal
frame that houses and protects the unit.
 You will find that there are a few items that need to be installed. DO NOT assemble until
you remove the metal frame.
 Position the steering wheel into place. A bolt, included, needs to be positioned and
tightened in order to properly secure the steering wheel into place.
 Besides the steering wheel, the driver seat needs to be positioned. This is done by lifting
the seat into position against the base tracks that are secured. The seat will then be
positioned along the track. In order to ensure proper fit – the handle of the bottom of
the physical seat will need to be held open.
 Install grass deflector and make sure it remains attached to the mower at ALL TIMES!

Steering Wheel Installation

 Remove and dispose of any packaging.
 Lift the Steering Wheel Section and carefully insert the neck of the steering wheel
into the steering wheel sleeve (fig 1.1).
 Carefully position the neck over the steering shaft and align the pre-designated holes
(fig 1.1). NOTE: It is designed to fit in one direction. Please take your time when
sliding the neck over the steering shaft.
 Use the supplied bolt to secure the steering wheel to the shaft (fig 1.2).
Neck
Steering
Wheel
Sleeve
Shaft
IMPORTANT: ENSURE THAT ANY WIRES ARE POSITIONED AWAY FROM THE SHAFT!
ASSEMBLY SET UP – Overview
Pre-designated
holes
Fig 1.1
Bolt
Fig 1.2
9