Seat Installation - Recharge Mower G2 Safety & Operating Instructions Manual

Seat Installation

 Carefully slide seat wiring through the pre-designated hole in seat plate.
 Align the tracks attached to the seat to the tracks on the seat plate. Carefully pull the
seat lever (near the front of the seat) to slide the seat into place. NOTE: Slide until
the seat is securely locked into place.
 Next, lift the seat plate (now securely attached to seat) and connect the seat cord to
the connector. NOTE: Make sure the seat cord is properly connected to the
connector.
 Lower the seat plate and ensure it is securely fastened into operating position.
Seat
Seat Plate
Fig 1.5
Fig 1.3
Pre-designated hole
within seat plate
Step 1
Securely fastened
Step 3
Seat Wiring
Fig 1.6
Seat Cord
10
Fig 1.4
Seat Lever
Step 2
Step 4 Seat cord connected
to the connector