Settings; Handset Settings; Setting The Username; Changing The Ringer Level - IBM -3920 Installation And Operating Manual

Handset Settings

You can change the setting on the handset in the
programming menu.
The settings that can be changed in the programming menu
are:
• Username Change the eight character name that is
displayed when the phone is idle.
• Ringer Level Change the volume of the ringer, either
High, Low, or Off.
• Ring Tone Change the way the ringer sounds on the
handset.
• Time and Date Change the time and date.
• Area Codes Allows you to set your home area code, and
local area codes if you have 10-digit dialing, for Caller ID callback. You can
have as many as six local area codes.
• Key Beeps Allows you to either enable the phone beep each time a key is
pressed or disable it.
• Flash Time Allows you to adjust the Flash pause time to accommodate the
phone service in your area.
• Pause Time Allows you to adjust the number of seconds that a pause lasts
when programming your speed dial numbers.
• Tone/Pulse Mode Allows you to select the dialing mode, either Tone or Pulse.
• Line In Use Chk When on, prompts you with "Line In Use Interrupt?" if the
phone line is already being used by another extension.
• Factory Default Resets all the handset settings, including the speed dial
directory, back to the factory defaults.
Note: At any time during options programming you can quit and the settings
that you have selected will be saved. Quit the options menu by pressing
B/Exit or let the menu programming time out by not pressing any
key for 15 seconds.

SETTINGS

Mute Key
Up/Down Key
17

Setting the Username

s
t
Talk
1 2
ABC 3
DEF
4 5 6
GHI JKL MNO
7
PQRS 8 9
TUV WXYZ
*
0 #
Flash Monitor Redial

Changing the Ringer Level

Talk
1
2 3
ABC DEF
4 5
GHI JKL 6
MNO
7 8 9
PQRS TUV WXYZ
*
0 #
Flash Monitor Redial
SETTINGS
1. Press and hold the Mute key on the left side of the
handset to enter the programming menu.
>Username
Ringer Level
Ring Tone
OK
2. Press T/OK.
Enter Username
OK
3. Use the dial pad to enter the username (see "Letter
Table" on page 32), up to eight characters.
4. Press T/OK.
>Ringer Level
Ring Tone
Time and Date
OK
5. Press B/Exit to return to the idle screen.
1. Press and hold the Mute key on the left side of the
handset to enter the programming menu.
>Username
Ringer Level
Ring Tone
OK
2. Press M to go to the Ringer Level programming option.
>Ringer Level
Ring Tone
Time and Date
OK
3. Press T/OK.
Ringer Level
Low
OK
4. Press L or M to select between High, Low, and Off.
5. Press T/OK.
>Ring Tone
Time and Date
Area Code
OK
6. Press B/Exit to return to the idle screen.
18
Exit
Exit
Exit
Exit
Exit
Exit
Exit