Checking - Samsung VP-W80 Owner's Instruction Book

ENGLISH
Troubleshooting Check

Checking

If you run into any problem using the camcorder, use
the following table to try and resolve the problem.
If these instructions do not allow you to solve the
problem, take a note of:
The model and serial number marked on the
bottom of the camcorder.
Your warranty, if applicable.
Then contact your nearest authorized service centre.
Symptom
You cannot switch the Check the battery pack (see page 19)
camcorder on. or the AC power adapter. (see page 18)
Start/Stop does not Check the POWER set it to CAMERA.
operate while shooting. You have reached the end of the
cassette.
Check the record protection tab on
the cassette. (see page 22)
The camcorder goes You have left the camcorder set to
off automatically. STANDBY for more than 5 minutes
without using it.(see page 24)
The battery pack is fully used up.
(see page 21)
The battery pack is The atmospheric temperature is
quickly exhausted. too low. (see page 21)
The battery pack has not been
charged fully.(see page 19)
The battery pack is completely dead,
and cannot be recharged.
Use another battery pack.
You cannot eject The battery pack is fully discharged.
the cassette from A mechanical fault may have
the compartment. occurred. (see page 57)
The DATE/TIME The lithium battery is not installed or
indicator flashes more is fully used up. (see page 17)
than 2 times when you
set the camcorder to
CAMERA.
58
Explanation/Solution
Kontrola, fie‰ení problému
Kontrola
CZECH