Troubleshooting
Checking
+
If you run _ntoany problem using the carncorder, use the following table to troubleshoot the problem
+
If these instructions do not allow you to solve the problem, take a note of
•
The model and serial nurnber marked on the bottom of the camcorder
•
Your warranty rf applicable
+
Then contact your nearest authorized serwce center
Symptom
ExpJanatmnlSolutlon
You cannot switch the
•
Check the battery pack Isee page 231
camcorder on
or the AC power adapter [see page 22_
Start,Stop does not
•
Check the POWER set it to CAMERA
operate while recording
•
You have reached the end of the cassette
•
Check the record protecbon tab on the cassette [see page 26)
The camcorder goes
•
You have left the camcorder set to STANDBY
off automatically
for more than 5 i_ilrlutes without using it rsee page 281
•
The battery pack is fully used up [see page 25)
The battery pack _s
•
The atmosphenc temperature _stoo low isee page 25}
quickly exhausted
•
The battery pack has not been charged fully Isee page 231
•
The battery pack is completely dead and cannot be recharged
bse another battery pack
You cannot eject the
•
The battery pack is fully used up
cassette from the
•
A mechanical fault mlgflt have occurred Isee page 68_
compartment
The DATE TfkIE indicator
•
The llthum battery _snot installed or _sfully used up Isee page 211
flashes more than 2 braes
when you set the
camcorder to CAMERA
The playback p_cture
•
The wdeo heads m_ghtbe d_dy Isee page 661
iS poor
You cannot operate any
•
A mechanical fault mlgflt have occurred Isee page 68)
fuqctlons on the camcorder
I ENGLISH]
A