Yeti Cycles SB5+ Owner's Manual page 13

ASSEMBLY
21.
Align the front shock eyelet to the mounting
points on the front triangle and secure with a
guide pin.
23.
Slide the shock mounting pin over the guide pin
and push it through the frame and the shock.
26.
22.
Place the 8.5mm washer (300030069) on the
front shock mounting pin (300030262) and lightly
grease the pin shaft.
24.
Place the 6.5mm washer (300030062) over a
Male Ti bolt (300030151). Apply Blue LocTite
to the threads. Using two 5mm allen wrenches
tighten the male bolt into the shock pin.
*Torque to 7 Nm
25.
Tighten a male Ti bolt (300030151) into the rear
shock pin (300030288) ensuring that it is fully
threaded into the pin. Slide a 8.5mm washer
(300030069) over the pin and lightly grease the
pin shaft.
27.
Place the 6.5mm washer (300030062) over a
Male Ti bolt (300030151). Apply Blue LocTite
to the threads. Using two 5mm allen wrenches
tighten the male bolt into the shock pin.
*Torque to 7 Nm
ASSEMBLY
26.
Slide the rear shock pin over the guide pin and
push it through the swingarm and shock.
28.
FRAME ASSEMBLY IS COMPLETE.
27.