This signal word indicates important information (e.g. material damage), but does not indicate hazards. Info Information marked with this symbol helps you to carry out your tasks quickly and safely. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
• Only transport the device in an upright position. • Do not cover or transport the device during operation. • Only use original spare parts, for otherwise safe and functional operation cannot be ensured. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 4
Do not spill any diesel, kerosene or fuel oil! Do not inhale the vapours nor swallow any fuel! Avoid skin contact! oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Switch the device off and disconnect it from the mains. 3. Remove persons from the danger area. 4. Do not reconnect a defective device to the mains. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 6
Upper part of the housing Transport handle Control panel Tank Air inlet with protective grid Pressure gauge Wheel Tank filling level indication Fuel tank cap Air outlet oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Assembly Upon delivery the device is already partially preassembled. The support frames, wheels and transport handle still need to be mounted. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 8
Mounting the transport handle 3. Slide the washers onto the axle. 1. Use 2 large screws each to affix the transport handle at the two support frames for the transport handle. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 9
ü Only use fuel suitable for the device (see technical data). 1. Position the device on firm, level and incombustible ground. 2,5 m 1,25 m 1,25 m 1,25 m oil heater IDX 20 D / IDX 31 D / IDX 50 D...
This value should be higher than the current room temperature. ð The following note only applies to IDX 31 D and IDX 50 D: The desired room temperature is displayed via the desired room temperature indication (12). oil heater IDX 20 D / IDX 31 D / IDX 50 D...
The fan does not start, even though the device is connected and switched on: • The thermostat setting might be too low. Turn up the thermostat setting. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 12
• Power failure: In the event of a power failure the ignition is extinguished, the device switches off immediately. After a power failure the device will not restart automatically, it has to be started via the on/off switch. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 14
3. As indicated in the figure use a wrench to open the screw at the bottom of the tank. 4. Drain the fuel into the collection container. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 15
1. Unscrew the pressure gauge. 3. Remove the protective grid. 2. Loosen the hexagonal bolts at the filter housing. 3. Remove the filter housing with filters and sealing. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 16
3. Allow the foam filter to dry completely. Do not put any wet filters into the device. 4. Insert both filters into the filter housing (33). Ensure the proper seating of the seal (31). oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 17
2. Place the upper part of the housing on the device. 3. Tighten the 6 screws at the upper part of the housing. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
23 kg 26 kg Wear hearing protection. Excessive noise can lead to hearing loss. Fuels The following fuels are approved for the device: • EL fuel oil • Diesel oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 19
Wiring diagram IDX 20 D oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 20
Wiring diagram IDX 31 D oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 21
Wiring diagram IDX 50 D oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 22
Overview of spare parts and spare parts list IDX 20 D Info The position numbers of the spare parts differ from those describing the positions of the components mentioned in these instructions. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 23
Left push Frame Fixing Plate Split Pin Burner Head Right push Frame Fixing Plate Handle Nipple Left Wheel retaining Plate Power Switch Spark Plug Kit Right Wheel retaining Plate Thermostat oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 24
Overview of spare parts and spare parts list IDX 31 D Info The position numbers of the spare parts differ from those describing the positions of the components mentioned in these instructions. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 25
Left push Frame Fixing Plate Split Pin Burner Head Right push Frame Fixing Plate Handle Nipple Left Wheel retaining Plate Power Switch Spark Plug Kit Right Wheel retaining Plate Thermostat oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 26
Overview of spare parts and spare parts list IDX 50 D Info The position numbers of the spare parts differ from those describing the positions of the components mentioned in these instructions. oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Page 27
Left push Frame Fixing Plate Split Pin Burner Head Right push Frame Fixing Plate Handle Nipple Left Wheel retaining Plate Power Switch Spark Plug Kit Right Wheel retaining Plate Thermostat oil heater IDX 20 D / IDX 31 D / IDX 50 D...
Trotec GmbH Grebbener Straße 7, D-52525 Heinsberg Phone: +49 2452 962-400 E-mail: info@trotec.de Place and date of issue: Heinsberg, 20.08.2019 Detlef von der Lieck, Managing Director oil heater IDX 20 D / IDX 31 D / IDX 50 D...