Table of Contents
Advertisement
3 GETTING STARTED
3.1 FITTING BATTERIES
Your gauge may be used with dry cell batteries or rechargeable
batteries. 2 x LR6 (AA) alkaline batteries are supplied with this gauge.
When the battery voltage is low the entire display will start to flash. When
this occurs the batteries should be replaced.
To fit or replace batteries:
1. Locate battery compartment cover at top of gauge.
2. Unscrew battery compartment cover.
3. Referring to battery polarity instructions on rear of gauge, insert bat-
teries into gauge ensuring correct polarity.
4. Replace battery compartment cover.
Note: Remove the batteries from the gauge if it is to remain unused for
a long period of time. This will prevent damage to the gauge in the event
of malfunction of the batteries.
3.2 CHOOSING THE TRANSDUCER
When you purchased your gauge you should have also purchased a
suitable transducer for your application. If you have not yet done so, refer
to "Transducers" on page 22, which will help you identify the correct
transducer type. Alternatively contact Elcometer NDT, your local
Elcometer NDT supplier or visit www.elcometerndt.com
Battery
compartment
cover
4
Advertisement
Table of Contents
