Table of Contents
Advertisement
3. Having achieved a stable reading, remove the transducer. If the displayed value changes from the
value shown while the transducer was coupled, repeat the previous step.
4. Press
.
On the display, MM (or IN) will start flashing on and off.
5. Use the
and
sample of material.
6. Press
.
The display flashes 1OF2.
7. Repeat steps 2 to 6, this time with the transducer in contact with the second sample/location of the
material being tested.
The gauge displays the sound velocity value it has calculated based on the thicknesses of the sample
piece.
Your gauge is now ready to perform measurements.
11
arrows to adjust the displayed thickness until it matches the thickness of the
Advertisement
Table of Contents
