Tilt-In-Space Mechanism; Q.standard Backrest - Sunrise Medical Quickie Iris Owner's Manual

ENG LI S H
P. TILT-IN-SPACE MECHANISM
The tilt-in-space mechanism is installed by Sunrise. Two cable/trigger mechanisms positively lock the chair in
place from -5º to 60º depending on the set-up. The Quickie/Zippie IRIS has the capability to provide from 0º to
5º of forward tilt. The Caregiver or User of this chair should not attempt to make a forward adjustment on
their own. This adjustment must be performed by an authorized supplier.
1. Rocker Cover removal
NOTE– Rocker arm cover is not available with the Folding Zippie IRIS.
a. Remove the (4 or 5) screws (A) that hold the cover to the Rocker Frame (B).
b. Remove the Rocker Cover (C) and store with screws in case you need them later.
22
2. Tilt-stops Adjustment
NOTE– When using tilt stops, you must first remove the Rocker Cover.
Adjustments can be made to limit the amount of tilt (rotation) that the chair provides by using the tilt-stops (D).
a. Loosen and remove the retaining screw (E).
b. Locate the tilt-stops to the desired limit either anterior or posterior.
c. Each half of tilt stop assembly should plug into directly opposing holes on the rocker (F), then secure in
place by tightening the screw (E).
23
3. Cable Adjustment
NOTE– Do not use lubricants on the components or assembly.
a. Loosen the jam nut (G).
b. Rotate the cable adjuster (H) until slack is removed from the cable. Make sure the plunger pin can fully
extend and retract after adjustment and that pins engage the rocker when triggers are released.
c. Tighten jam nut (G).
Q. STANDARD BACKREST
24
1. Angle Adjustment
a. Loosen rear bolt ( I ).
b. Loosen and remove angle adjustment bolt ( J ).
c. Set backrest at desired angle using pre-set holes.
d. Replace and tighten the front bolt ( J ).
e. Tighten rear bolt ( I ).
f. Repeat on other side.
IMPORTANT NOTE– The adjustment on each side of the chair should be exactly equal.
NOTE -Use a torque setting of 75 in.-lbs. When setting-up the angle adjustment of the stroller handle.
NOTE - Backrest position may also need adjusting to maintain optimal CG alignment and stability.
21
IX. DEALER SERVICE & ADJUSTMENT
25
24
I
J
MK-100151 Rev. B