More Blink Features; Internal Energy Meter; Flexible Communications; Safety - Blink WE-30C Owner's Manual

More Blink features

Internal energy meter

Blink has a built-in energy meter, so some local utilities may not require the installation of a second
meter.

Monitors energy usage and demand

Provides certified energy and metered demand response, so it can support electric utility electric
vehicle billing when certified to ANSI C12.20 and IEC standards (if supported by your local
electric utility)

Supports energy usage data evaluation

Flexible communications

Blink has many ways to connect to the Internet:

Ethernet Local Area Network (LAN)

IEEE 802.11b/g (Wi-Fi)

Cellular Modem (applicable models)

Safety

Blink safety features:

Certified to UL 2594 – Electric Vehicle Supply Equipment

Will not dispense power unless the connector is properly latched in the vehicle's inlet – with an
audible click

Communicates with your vehicle when the Blink connector is plugged into the vehicle inlet, so
the vehicle will not drive until the connector is unplugged

Turns off the charging power if the Blink connector or cable is subjected to excessive strain

Contains a charge circuit interrupting device (CCID) and a ground monitoring circuit

Meets all National Electric Code and UL requirements related to electric vehicle charging
systems

Even more from your Blink


Restarts automatically after a power outage

Provides adjustable output current to support electric utility demand response requests, where
available (and with your permission)

Complies with the Americans with Disabilities Act (ADA), and can be installed in a variety of
configurations to meet your needs

Prevents energy theft with an optional tamper-evident seal, similar to the seal on your utility
meter. Your Blink charging system installer will install this seal
6
OM0001_L2_R_WM_USAv2.1