Table of Contents
Advertisement
Mounting the Invacare®Octave.
Receiving the bed on the trolley: (2 persons required)
1.
Apply all 4 braked castors on the trolley.
2.
Apply all 4 braked castors on the bed.
3.
Remove the delivered equipment from the trolley.
4.
Lower the bed and the trolley, into horizontal
position -standing on the bed castors.
5.
Dismount the trolley from the bed.
When lowering the bed into horizontal position 2 persons are required.
Connect Invacare®Octave to the mains.
For ergonomic working position:
Raise the bed (hi/low) to approx. 60 cm above floor level. Ref. chapter 2 "Operation of the Invacare®Octave".
1. Assembling the fittings.
a) Push bed end through the pipes on the top frame.
(Visible insertpipe is about 4.5 cm).
b) Tighten the bed end with enclosed screws.
2. Mounting the wooden bed end
a)
Slide the wooden bed end into the U-profile.
Mounting wooden adapters and wooden siderail (accessories).
1. Mounting wooden trim.
a) Remove the exposure on the bed end.
b) Mount the Wooden trim with the enclosed mounting
screws.
c) Make sure that all 4 Wooden trims have been correctly
mounted/tightened.
10
Advertisement
Table of Contents
