Slotshow; Sfpshow - Brocade Communications Systems X6-8 Hardware Installation Manual

sensor 45: (Fan
sensor 46: (Fan
sensor 47: (Fan
sensor 48: (Power Supply) is Ok
sensor 49: (Power Supply) is Ok
sensor 50: (Power Supply) is Ok
sensor 51: (Power Supply) is Ok

slotShow

Use this command to display the current status of each blade in the system. Depending on the option used, the command retrieves
information on blade type, blade ID, status, Brocade model name, and power usage for each slot in the switch or chassis. Use the -m
operand to display the blade model name and status.
Following is an example of slotShow output.
NOTE
The most common status is shown. A status of Faulty (51) would display for a POST failure during power-on or a blade hot-
plug.
chassisX6-8:admin> slotShow -m
Slot Blade Type
--------------------------------------------------
1 CP BLADE
2 CP BLADE
3 SW BLADE
4 SW BLADE
5 AP BLADE
6 SW BLADE
7 CORE BLADE
8 CORE BLADE
9 SW BLADE
10 UNKNOWN
11 SW BLADE
12 SW BLADE
switch:admin>

sfpShow

Use this command without operands to display a summary of all installed SFPs. For each port, the command displays the SFP type and,
for serial ID SFP, the vendor name and SFP, serial number, and speed capability (in Gbps). Use this command with a port number to
display detailed information about the serial ID SFP in the specified port.
Following is example of sfpShow output.
chassisX6-8:admin> sfpshow
Slot 3/Port 0: --
Slot 3/Port 1: --
Slot 3/Port 2: --
Slot 3/Port 3: --
Slot 3/Port 4: --
Slot 3/Port 5: --
Slot 3/Port 6: --
Slot 3/Port 7: --
Slot 3/Port 8: --
Slot 3/Port 9: --
Slot 3/Port 10: --
Slot 3/Port 11: --
Slot 3/Port 12: --
Slot 3/Port 13: --
Slot 3/Port 14: --
Slot 3/Port 15: --
Brocade X6-8 Director Hardware Installation Guide
53-1004105-07
) is Ok,speed is 7509 RPM
) is Ok,speed is 7462 RPM
) is Ok,speed is 7444 RPM
ID Model Name
175 CPX6 ENABLED
175 CPX6 ENABLED
178 FC32-48 ENABLED
178 FC32-48 ENABLED
186 SX6 ENABLED
178 FC32-48 DISABLED
176 CR32-8 ENABLED
176 CR32-8 ENABLED
178 FC32-48 ENABLED
VACANT
178 FC32-48 ENABLED
178 FC32-48 ENABLED
Status
Using monitoring commands
107