Brocade Communications Systems X6-8 Hardware Installation Manual page 191

2. Perform one of the following steps:
• If you need to power down the chassis to remove a fan assembly, enter the sysShutdown command. When command
output indicates the chassis has completed shut-down, remove power cords from all power supply assemblies.
• If you can hot-swap the fan assembly, go on to the next step.
NOTE
Replace fan as soon as possible to avoid overheating and eventual system shutdown.
3. Loosen the captive screw at each end of the fan assembly until the screw releases from the chassis. Use a #1 Phillips
screwdriver if tightened.
4. Grasp the handle and pull, sliding the fan assembly from the chassis while supporting the fan assembly from beneath as you
remove it.
FIGURE 58 Removing and installing a fan assembly
5. If leaving power on for replacement (hot swap), be sure to replace the fan assembly as soon as possible.
Brocade X6-8 Director Hardware Installation Guide
53-1004105-07
Removing a fan assembly
191