Factor ONE Disc Assembly Manual page 12

DISC
3-20
For traditional or continental brake routing, use Park
IR-1 to route brake hoses as pictured.
3-22
Headset Spacers Bolt Spacers & Bolt Lengths
Stack Height Bolt Spacers*
ZERO Yes
5mm No
10mm Yes
15mm No
20mm Yes
25mm No
30mm Yes
35mm No
Choose the correct bolt length and spacer configuration
for your desired stack of headset spacers.
*If required install 5mm bolt spacers as pictured in yellow in figure 3-23.
** A 1mm flat washer is always required on each of the 4 bolts.
For UK or "moto" brake routing, use Park IR-1 to route
brake hoses as pictured.
3-23
Bolt Length**
20mm
30mm
40mm
50mm
Assembly Manual
3-21
Connect Shimano JC 200 to JC 130 and slide barstem into
position.
3-24
Install rear barstem cover and tighten bolt to 1 Nm
Install the 4 x M6
bolts and evenly
tighten to 8 Nm.
08