Fluke Victoreen 190 Operator's Manual page 23

All but one of the Operational Modes may be disabled via the Model 190-1A Communicator; one default
mode must be enabled for the instrument to operate properly.
Changing the Display Mode (Rate/Integ)
The front panel Rate/Integ button toggles the alphanumeric display between the digitized rate value and
the integrate value. Press Rate/Integ to automatically change the display mode.
The Rate/Integ button may be disabled (and the display mode fixed) via the optional Model 190-1A
Communicator.
Logging Displayed Data (Log)
If the Data logging function is selected to be operational (via the optional Communicator), currently
displayed data will be stored for future retrieval. The procedure for logging data depends on the Log
Mode (Manual or Timed, with or without location identifiers, as selected via the communicator).
In the manual mode, displayed data is logged by pressing the front panel Log button. The following
message will appear in the alphanumeric display:
Data logging in manual mode. ready
In the timed mode, data is logged at specific intervals. The following message will appear in the
alphanumeric display:
Data logging in timed mode. ready
Remote Communication (Optional)
Communication with the Model 190I and Model 190 is accomplished via the Model 190I-1A
Communicator that plugs into top of the instrument.
The Log Mode is always inactive when the unit is
turned on and data logging can only be activated
through the optional Communicator.
Mode has not been activated, a NOT IN LOG
MODE message will be displayed when the Log
button is pressed. When in the data logging mode,
the instrument ON/OFF button is in active and the
instrument will stay on until the data has been
retrieved. Refer to the Instruction Manual provided
with the communicator for further information and
instructions.
For remote communication, use the Model 190-
1A Communicator and the 94190C00 software
provided.
For additional information and operation of
remote communications, refer to the 190003
instruction manual provided with the Model 190-
1A.
Changing the Operation Mode (Mode)
NOTE
If the Log
NOTE
Operation
3
3-11