Weighing Frame; Motor And Feeding System - Conair TrueFeed User Manual

3.2 Weighing frame

IMPORTANT: Do not touch the weighing frame (and dispensing unit) while feeding.
It will have influence on the feeding.
IMPORTANT: Do not touch the safety bolts under the weighing platform. These are for overload
protection. There must be some space between the safety bolts and the frame.

3.3 Motor and feeding system

There are two main feeding systems, the dispensing cylinder and the feed screw.
(For more information see Section 5)
The serial number for the motor can be found on the
backside of the motor.
Motor shaft:
The motor shaft is equipped with one flat side which
fits precisely in the shaft of the dispensing cylinder.
To connect the dispensing cylinder, put it on the
motor shaft while turning it to the keyed section to find
the flat side of the shaft, then press the dispensing
cylinder completely backwards.
Safety bolts
(total of 4)
Hopper loader tube support
(when option selected)
Balance frame
4
Transport protection pin
(Remove before operation)
Weighing frame
Dual Feed TrueFeed Manual