Consumption - Conair TrueFeed User Manual

Recommended settings for ME hopper loader:
For the filling start weight, use a level shown in the filling start figure on the previous page. When using
a high weight level the amount of filling cycles will increase.
Use a fill time that will allow the material to cover at least the sight glass in the back of the hopper.
Overfilling of the hopper should be avoided.
Recommended settings for MV hopper loader
For the filling start weight, use a level shown in the filling start figure on the previous page. When using
a high weight level the amount of fill cycles will increase.
Use a fill time that will allow the vacuum chamber of the MV-Loader to be almost completely filled.
Overfilling of the vacuum chamber should be avoided.
Do not use an empty time that is longer than necessary, but not too short of an empty time that can
cause a decreased capacity of the MV-hopper loader.
For the amount of filling cycles, use a cycle amount that will allow the material to cover at least the sight
glass in the back of the hopper. Overfilling of the hopper should be avoided.

7.9 Consumption

The CONSUMPTION menu will be visible when the ME or MV filling system is enabled in the
CONFIGURATION menu. Without use of the optional ME or MV filling system, accurate working of the
consumption registration is not supported.
With the Consumption function it is possible view the total quantity of material feed by the TrueFeed. The
consumption is saved in the memory and remains in the memory even when the unit is shut off or unplugged.
To reset the consumption go to Reset and select "YES" and press "ENTER".
30 Dual Feed TrueFeed Manual