Conair TrueFeed User Manual page 11

All Conair TrueFeed feeders are equipped with a 2A (LT) stepper motor as standard. However, if you are using
an A30 feed auger, a 4.5A (HT) stepper motor will be supplied. An A20 auger can also be connected to the
4.5A (HT) motor.
Do not select the HT setting in the control if a LT motor is connected. This will damage the motor.
If the LT motor is selected and a HT motor is connected there will be less motor torque, which can
influence the feeding.
The controller of the feeder makes a distinction between two groups of materials, normal granules and micro
granules. To determine the kind of material in your application use the description below.
Normal Granules:
(NG)
Micro / Mini Granules:
(MG)
The term Micro/Mini Granules also
includes free flowing powder.
* For other sizes contact a Conair representative.
The actual capacity of the feeding system depends on:
The volume weight of the material (bulk density)
The specific weight of the material (specific density)
The granular shape of the material
The granule size
The surface structure of the material
Granular material can be normal or micro. The granular material and powder material has to be free flowing,
non-static and not sticky.
Stepper motor 2A
(LT)
Material types
Ø
L
< 4 mm
Ø
ø
L
< ø2.5 mm L < 3 mm *
Ø
Stepper motor 4.5A
(HT)
L < 4 mm *
7 Dual Feed TrueFeed Manual