Table of Contents
Advertisement
2. General Information
2.1 Safety
The equipment is only designed and may only be used for the feeding of dry additives.
Any use that is not in conformity with the instructions is considered improper and as such frees the
manufacturer from any liability regarding damage to objects and/or persons.
Before switching on the unit for the first time, ensure that the main power voltage applied is between
80 VAC and 260 VAC.
Always switch off the Conair control cabinet and disconnect the main power plug from electrical power
before performing maintenance.
Ensure that all parts are securely fixed to the injection molding machine.
Dangerous voltages are still present inside the control cabinet for up to 2 minutes after the power has
been switched off.
2.2 Certification
The Conair Dual TrueFeed is designed and produced in conformity with the following European
regulations:
Standards for machinery (health, safety, environment)
EMC (electromagnetic compatibility)
VEM (safety electric material)
98/37/EC, Annex 1
2.3 Operating environmental conditions
The unit must be protected against weather conditions
Operating temperature -4 to 158 F {-20 to 70 C}.
Protection class: IP-50
2
Dual Feed TrueFeed Manual
Hide quick links:
Advertisement
Table of Contents
