Changing From Feeding Cylinder To Feed Screw - Conair TrueFeed User Manual

6.4 Changing from Dispensing cylinder to Feed screw
In relation to the maximum capacity of the dispensing cylinder, it might be necessary to change from the
selected dispensing cylinder to a feed screw. The feed screw system consists of a rotating auger in a
non-rotating tube. (See the detailed instructions listed below.)
5
1
2
To install the feed auger:
1. Detach the motor quick release clamps and take out the motor from the hopper.
2. Dismount the throat adaptor connection flange (1) by removing 4 socket-head screws.
3. For use with a dispensing cylinder the throat adaptor connection flange (1) is equipped with a ball bearing
(5). When using an auger screw system, the ball bearing must be removed. The metal ring (2) that is fixed
on the feed screw tube fits directly on the throat adaptor connection flange.
4. Dismount the dispensing cylinder (3) and mount the auger screw (4) with the M5 bolt.
5. Replace the motor and auger by closing the motor quick release clamps.
For cleaning, the motor and auger can easily be removed.
POSSIBLE COMBINATIONS
Note that the A20HT and A30HT auger
screws have a larger diameter motor
mounting for the larger, high torque motor
shaft.
3
4
GX / GLX / HX
G / GL / H
9
A20
Art.nr:H000014
Included ball bearing
Art.nr:H000010
Included seal
Dual Feed TrueFeed Manual
Art.nr:H000002