Cold Storage Exit Detection
In Automatic mode, cold storage exit detection occurs when the sensors identify a
quick rise in the ambient temperature.
•
•
Note: When the heaters turn On, the icon changes from a snowflake
Turn the Heaters On/Off in Automatic Mode
When Automatic mode is enabled, you can still manually turn the heaters On or
Off while in cold storage.
Tap the snowflake
•
•
How Manual Mode Works
Manual mode gives you full control over turning the heaters On or Off.
When Manual mode is enabled, automatic cold storage enter/exit detection is no
longer used to control the heater behavior. To turn the heaters on/off, you must tap
a button on the Heater screen in the Settings app. Full power is used for defrosting.
Manual mode is disabled by default.
Turn Manual Mode On/Off
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Heater.
3. Tap the Automatic/Manual button to switch between the Automatic or Manual
4. Tap the Heater On/Heater Off button to control the heaters.
Dolphin CN80 Mobile Computer
If Preemptive Heating is disabled (default) and the Chill time has expired, the
system turns the heaters On at full power when a cold storage exit is detected.
If Preemptive Heating is enabled and the Chill time has expired,
the system starts the Preemptive delay time. When the Preemptive delay time
expires, the heaters enter a low-power pre-heat stage. Pre-heating keeps the
windows warm to minimize condensation and frost when the computer is
removed from cold storage allowing for quicker defrost times. The system turns
the heaters On full power when a cold storage exit is detected.
or heater icon
If Preemptive Heating is disabled, the heater Preemptive delay time is not
used and pre-heating does not automatically start, but the snowflake icon
can still be tapped to turn On the heaters for pre-heating.
If you enabled Preemptive Heating, the heater Preemptive delay time stops
when the icons are used to turn the heater On or Off.
mode. The active mode appears on the button. When Manual mode is enabled,
the Heater On/Heater Off button next to the mode button is active.
in the status bar.
to a heater
.
23