Mira PLATINUM Installation Manual page 18

Digital Mixer Valve
Position and Signal Test
Wireless
Controller
Important! When choosing a position for the Digital Mixer Valve in relation to the
Wireless Controller and the Shower Fittings, consider the following points:
The Wireless Controller can be sited up to 10 m from the Digital Mixer Valve.
However, wall thicknesses and construction types may affect the remote signal
strength and thereby reduce the range. The Controller range should be tested
on site prior to installation to ensure shower's reliability.
Refer to Section  INSTALLATION "Important Information Regarding Radio
Controlled Devices".
The length of pipework running from the Digital Mixer Valve to the Shower Fitting
will have an effect on the showering temperature and the response time when
changing the temperature using the Wireless Controller. The shorter the length
of pipework from the Digital Mixer Valve the better the shower will respond. It
is recommended that this length does not exceed 3 m (Ceiling Fed Fitting) or
4.5 m (Rear Fed Fitting).
The ambient temperature of Digital Mixer Valve site (loft space, airing cupboard
etc...) can have an effect on showering temperature. Insulate all pipework as
required, particularly from the Digital Mixer Valve to the Shower Fitting.
Important! Insulate pipework only. Do not attempt to insulate or cover the
Digital Mixer Valve.
Up to 10 m
Up to 4.5 m total distance to
Right Angle Connector (RAC)
Rear Fed
Fitting
Up to 3 m
Shower
Outlet
Ceiling Fed
Fitting
18
3 amp switched
fused spur
ISOLATE MAINS ELECTRICITY BEFORE
REMOVING COVER!
DIGITAL MIXER 2 WIRELESS
MIRA DM2 WIRELESS
HP/COMBI
1666.009
N85A
MANUFACTURED
POWER: 230 V AC 20 W
PROTECTION: IP24
MIN. SUPPLY PRESSURE: 50 kPa (0.5 bar)
MAX. WORKING PRESSURE: 500 kPa (5 bar)
MAX. STATIC PRESSURE: 1000 kPa (10 bar) (WRAS)
MAX. SUPPLY WATER TEMP: 65 °C
POSITION APPLIANCE OR
KOHLER MIRA LTD.
CHELTENHAM
GL52 5EP
TEL: (+44) 0870 241 0888
www.mirashowers.com
HOT COLD
F9001
Cold Water Inlet
Hot Water Inlet