Table of Contents
Advertisement
6.2 Preparing for use ( Important )
The rinse aid dispenser is fitted on all models, the detergent dispenser only on some.
If both dispensers are present put the external detergent and rinse aid containers in place and
insert the respective intake hoses on the rear of the appliance into them. Red hose: detergent,
blue hose: rinse aid.
Whenever the type of detergent or rinse aid is changed, it is ABSOLUTELY ESSENTIAL to flush out
the peristaltic pumps by placing the external intake pipes in water for a few cycles. Always use
only products specifically recommended for use in a professional dishwasher. Failure to comply
with this recommendation leads to forfeiture of the warranty entitlement on the appliance's
water system. Replacement of the internal tube of the detergent and rinse aid peristaltic pumps
is recommended every 12 months or 15.000 wash cycles, by the After-Sales Service.
6.3 Using the water softener (on models with this feature only)
The quantity of lime in the water (which indicates its hardness) causes
whitish marks on dry dishes and dishes also tend to lose their shine over
time. The dishwasher is equipped with an automatic water softener which
removes the substances that cause hardness from the water with the aid of
regenerating salt.
The first time the dishwasher is used, a litre of water must be poured into the
tank with the salt. Whenever the tank is filled, always take care to ensure that
the cap is firmly closed. The mixture of water and detergent must not get into
the salt tank, as this would impair operation of the regeneration system. In
this case warranty cover will be forfeited.
Before inserting the hoses into the containers, fit the weights (needed to
ensure that they always draw in liquid from the bottoms of the containers)
and the filters onto their ends as shown. If the detergent dispenser is not
factory-fitted, it can be retrofitted after ordering the relative kit.
IMPORTANT
:
13
Hide quick links:
Advertisement
Table of Contents
