Smeg HTY511DSUK Original Instructions Manual page 17

Autostart function
Regeneration frequency setup (models with softener)
* (Default value: H03; modify the parameter to suit the mains water hardness.
At first use, the salt tank has to be filled. It is subsequently sufficient simply to fill up with
regenerating salt when necessary.
Mains water hardness setting table
With values over 60°f an external water
treatment device must be used and the
regeneration frequency must be set on H00.
Importante:
During normal operation, the dishwasher will perform a number of washing cycles while
regeneration is in progress. During this time (5-6 cycles) the intake water will not be treated, but
this will not affect the washing quality.
Extra rinse
Set at "on" to start the cycle when the hood/door is closed.
Set at "off" to start the cycle after confirmation with the
start button
Durezza
Ppm-
°d gradi
mg/l
tedeschi
Rigenerazione disattivata
150 8,5
200 11
300 17
400 22,5
500 28
600 33,5
Rinsing is 10" longer than the standard in each washing
On: enabled – OFF: disabled.
17
.
Durezza
Livello
°f gradi
regolazione
francesi
H00
15 H01
20 H02
30 * H03
40 H04
50 H05
60 H06
cycle.