DAQ PCI-EK01 User Manual page 9

PCI-EK01 Users Manual (Rev 1.0)
(3) If the installation is completely finished, you can show below message window.
[Figure 2-5. PCI-EK01 Completing Device Driver Window]
(4) If the installation is completely finished, you can use the USB-DIO6400 board.
But, it confirm a driver normally installation in the following ways. Do the following steps to show
up the "Device Manager" window. [My Computer -> Properties -> Hardware -> Device Manager ->
Multifunction Adaptors -> "PCI-EK01"]
[Figure 2-6. "System Properties" window-"Hardware" Tab]
9-
- http://www.daqsystem.com